The 1997-2006 Ford exploration models come equipped through a quick-connect fuel filter. The key responsibility that the fuel filter is to store any form of fuel impurities from entering right into the fuel injectors so just clean fuel renders it come the injectors and also the engine. Change the fuel filter between 60,000 and also 75,000 miles. You deserve to purchase the quick-disconnect device that you will need for this task at most auto-parts stores.

You are watching: 2003 ford expedition fuel filter location


Park the Ford exploration in a well-ventilated place that has actually a level surface. Communicate the parking brake to store the vehicle from rolling.

Slowly eliminate the gas lid from the filler tube on the gas tank. This procedure will depressurize the fuel system and prevent fuel indigenous spraying as soon as the fuel present are gotten rid of from the fuel filter.


Slide under the driver side of the Expedition and also locate the fuel filter, i m sorry is an installed to the structure rail straight in prior of the gas tank. The fuel filter is a cylinder-shaped component through a quick-connect fuel line coming the end of each end. Slide the drip pan under the fuel filter.

Insert the end of the quick-disconnect tool into the end of one of the fuel lines. Then, press the tool inward into the fuel line. This will certainly release the fuel line from the fuel filter port. Pull out on the fuel heat at the very same time that the device is being pressed inward. Traction the fuel line right off the fuel filter port. Move the device to the various other fuel line and repeat the process.

Loosen the clamp from approximately the fuel filter through a flat-head screwdriver. Note the direction the the arrow on the side of the fuel filter. The new fuel filter will should be positioned v the arrow pointing in the very same direction. Then, pull the fuel filter out of the bracket and place it into the drip pan.

Position the new fuel filter right into the clamp with the arrowhead pointing in the proper direction. Tighten the clamp end the fuel filter v the screwdriver. Then, press both fuel lines right onto the fuel filter ports until each line locks in place. Once the present are thrust far enough onto the ports, the plastic clips will lock inside of the fuel lines. Then, progressively pull outside on the fuel lines come ensure that each fuel heat is secured to the fuel filter ports.

Slide the drip pan out from under the Expedition and screw the gas cap ago onto the filler tube till it clicks.

Turn the ignition to the accessory place for around five seconds and also then revolve it back to the turn off position. Repeat this a complete of 3 times prior to cranking the engine.

Crank the engine and inspect the brand-new fuel filter for indications of gas leaking around the fuel lines. Permit the engine to run for about 30 seconds. Then, revolve the engine off.


advice

The arrowhead that is imprinted top top the next of the fuel filter represents the directgion the fuel flow through the filter. The arrowhead must point toward the fuel line that is travel to the engine.

See more: How Much Is A Jerry Rice Card Worth ? Jerry Rice Rookie Card Value


Warnings

No smoking or open up flames roughly any form of fuel. Wear safety glasses or goggles when replacing the fuel filter. Refer to state and local legislations that pertain to the discarding of offered fuel and used fuel filters. Never dispose of fuel ~ above the ground.