Six cylinder 2 wheel drive automatic 93,000 miles.

You are watching: 2003 hyundai santa fe crankshaft position sensor location

whereby is the crankshaft sensor situated on this car? ns cannot discover it. Execute I must remove the intake? I view wires walk under the intake yet cannot phone call what they room for.
*

The crankshaft sensor is located at the front of the engine down at the timing belt pulley. Girlfriend will should remove the timing belt cover. Below is a diagram to aid you see what i am talk about. The six. Here is a guide that can give you an ext information top top the job:https://www.yellowcomic.com/articles/crankshaft-angle-sensor-replacementHere is what it will certainly be like (below) for four and also six cylinder engines.Please permit us recognize what happens.Cheers
*

*


ns looked for around an hour last night in this area and could not discover it. Is the under something else or hidden? I have the new sensor and know what it looks like, yet cannot view it on the car. I checked out the Hyundai dealership and asked a mechanic. The crankshaft sensor is over the starter ~ above the side of the block. A bit hard to obtain to, however I adjusted it and car is to run again.

I want to find the sensor, and possibly check out the component number. Or if any type of one knows exactly how to kindly help me?
The crankshaft sensor is in the next of the block, behind the exhaust manifold.
*
Part#391803E100 $74.27
Hey MUSA, The crankshaft place sensor is in the side of the block, behind the exhaust manifold.Here is a diagram to aid you locate it:Please permit us know what you uncover so it will aid others.Best, Ken
4 cylinder prior wheel drive manual. Wherein is the crankshaft place sensor and also how long does it take it to replace on a 2.4L?

*

*

Note:Part and also labor might vary in ~ location.https://www.yellowcomic.com/kpages/auto_repair_manuals_alldata.htm
mine 2004 Hyundai Santa Fe will not start. I already installed a new fuel pump and also still same. I was thinking might be the crankshaft sensor yet I carry out not know where that is. How can I uncover it?
You do not change parts and also hope the it works. That is walking to it is in costly and also a rubbish of time and money unless you are very lucky.You have to start through diagnostics to uncover out what is absent causing the non starting.
my SUV all of sudden would not change into second gear going down the highway. Ns babied that home and also noticed also that placing it in turning back the engine immediately quit. Idle the car and it is fine. Placing it in journey it jumps. So i took the end my computer inspect tool and it claimed the crankshaft sensor to be bad.So ns guess I need to understand where this is situated on the engine? Thanks, mark
i doubt that is her crank sensor, yet here is place in picture. If it still walk it have actually a transmission professional inspect it. It may be a branch or in require of transmission rebuild.
factor I stated the sensor is my tester gave me the p003 and also said crankshaft position sensor. Someone told me that ns would need to remove the timing belt cover and also crankshaft pulley. You are showing the sensor in ~ the top of the engine?
Hello, On mine Car, us Were in ~ A Stoplight around To turn Left and also The vehicle Stalled Out. It would Not Start appropriate Away, however After Pushing...
The auto Starts and Runs around 10 Seconds and also Then simply Stops, The Crankshaft Sensor and Timing Belt Were adjusted At Shop last Week, Could...

See more: What Does Ig Mean On Kik ? What Does Kik Mean And Stand For


Is there A Sensor the The computer Wants info From after The Engine has Been running For 3 Seconds?
My auto Does not Switch Off directly Away and I need to Stall The Engine To rotate It Off. After ~ I rotate The vital To turn off The Engine go A...