Also, Haynes (which is of small help) states to remove pin obelisk lock, but some various other advice is no saying that.

You are watching: How to remove rear axle shaft chevy

Help!



GM-Tech

Senior Enthusiast
\"*\"
Member 13,297 postsLocation:South Florida

Rear Axle obelisk Replacement

 

Removal Procedure

 

 

 

 

Raise the vehicle. Describe Lifting and also Jacking the automobile in general Information.

Remove the tire and wheel assembly. Describe Tire and also Wheel Removal and also Installation in Tires and also Wheels.

Remove the brake caliper. Refer to Brake Caliper replacement - rear in bowl Brakes.

Remove the behind cover and the gasket. Refer to Rear Axle housing Cover and also Gasket instead of .

Remove the pinion pillar locking bolt.

 

 

 

On axles without a locking differential, remove the pinion shaft.

 

 

 

On axles v a locking differential, eliminate the shaft part way. Turn the instance until the pinion shaft touches the housing.

 

 

 

On axles v a locking differential, usage a screwdriver, or a comparable tool, in stimulate to get in the differential case and also rotate the lock (1) till the lock aligns with the thrust block (2).

 

 

 

Push the flange that the axle tower (1) towards the differential.

Remove the C-lock (4) from the switch end that the axle pillar (1).

Important: as soon as removing the axle shaft, carry out not revolve the shaft. Rotating the tower will misalign the gears. Misaligning the gears will certainly make the assembly difficult.

 

 

Remove the axle tower (1) indigenous the real estate (5).

Installation Procedure

 

 

 

 

Important: very closely insert the axle shaft in order come not damages the seal.

See more: Fahrenheit To Celsius Convert 61 Degrees Fahrenheit To Celsius

 

 

Install the axle obelisk (1) right into the rear axle housing (5).

Slide the axle tower (1) right into place enabling the splines to interact the differential next gear.

On axles without a locking differential, ar the lock (4) on the button end of the axle tower (1).

On axles with a locking differential, save the pinion column partially withdrawn.

 

 

 

On axles v a locking differential, location the C-lock (1) on the axle shaft (3) so the the ends space flush v the thrust block (2).

Pull the shaft flange exterior in order to seat the lock in the differential gear.

 

 

 

Align the hole in the pinion column with the bolt feet in the differential case.

Notice: describe Fastener notification in Cautions and also Notices.

 

Install the brand-new pinion column locking bolt.

 

Tighten

 

• because that the 8.6 inch axle, tighten the pinion shaft locking bolt come 36 N·m (27 lb ft).

 

• for the 9.5 inch axle, tighten the pinion tower locking bolt come 50 N·m (37 lb ft).

 

Install the behind cover and the gasket. Describe Rear Axle housing Cover and Gasket replacement .

Install the brake caliper. Describe Brake Caliper instead of - rear in key Brakes.

Install the tire and also wheel assembly. Describe Tire and also Wheel Removal and Installation in Tires and also Wheels.

Fill the rear axle. Use the suitable fluid. Refer to Capacities - almost right Fluid and also Fluid and also Lubricant referrals in Maintenance and Lubrication.