JavaScript is disabled. Because that a far better experience, please enable JavaScript in your browser before proceeding.

You are watching: How to remove rear wiper arm ford expedition


*

I am trying to eliminate the complete rear wiper assembly in order come remove and replace the wiper motor. I eliminated the bolt the was hidden under the basic of the wiper however the wiper arm will not pull off. What rather is holding that on?
*

1971 Ford LTD 2 door convertible 429 4V. C-6 - 1970 Continental mark III 2 door Coupe 460 4V. C-6 2.80 axle1966 Lincoln continent 4 door Convertible 462 4V. C-6 3.00 axle - 1966 Mercury Park lane 4 door Breezeway 410 4V. C-6 2.80 axle
*

Yes... I discovered the nut under the pivot and also removed the nut. However the wiper arm still will not come off.
*

1971 Ford LTD 2 door convertible 429 4V. C-6 - 1970 Continental mark III 2 door Coupe 460 4V. C-6 2.80 axle1966 Lincoln continent 4 door Convertible 462 4V. C-6 3.00 axle - 1966 Mercury Park roadway 4 door Breezeway 410 4V. C-6 2.80 axle
*

You need to lever it off squarely. If you bar at the peak it will certainly jam, bar at the bottom it will certainly jam. Bar both top and bottom very same time, it will pop off. Be very closely not to mark what you are leveraging against, as paint will chip, trim will certainly bend, glass will shatter..
They make a small puller tool that sells in ~ the components stores for roughly $10 especially for these wiper chisels that have the right to be used likewise without doing any type of damage.
I purchase the wiper traction tool yet the wiper eight still will not budge. There is a steel ring under the nut, however that wont budge either. Possibly the wiper is suppose to screw turn off of the bolt? i wish there to be a video showing rear wiper removal for this particular vehicle... 2010 escape XLT 3.0.
1971 Ford LTD 2 door convertible 429 4V. C-6 - 1970 Continental note III 2 door Coupe 460 4V. C-6 2.80 axle1966 Lincoln continental 4 door Convertible 462 4V. C-6 3.00 axle - 1966 Mercury Park lane 4 door Breezeway 410 4V. C-6 2.80 axle
1) remove rear wiper arm. This is the most an overwhelming step, Most most likely you"ll have to reduced the arm off, but there are various other options. there is a tiny tab ~ above the basic of the wiper arm than deserve to be pulled out (in the same airplane as the wiper turns), this supposedly "unlocks" the wiper arm, Not certain if you have been under this course yet, however I check out this on other escape BBS.

See more: How Long Does It Take To Travel 100 Miles, How To Convert Miles To Hours


Someone asked for a picture? as you can see the is all scraped up because I have actually been poking and prying top top it because that days. P.S... I check out no clip holding that in, as far as I understand the 2010 escape XLT go not have a clip holding it in. That metal ring that looks like a washer does no come off either.
1971 Ford LTD 2 door convertible 429 4V. C-6 - 1970 Continental mark III 2 door Coupe 460 4V. C-6 2.80 axle1966 Lincoln continent 4 door Convertible 462 4V. C-6 3.00 axle - 1966 Mercury Park roadway 4 door Breezeway 410 4V. C-6 2.80 axle